Welding test of steel plate and steel tube
Related equipment: HATATEST Portable DR Inspection System
Solve the problem: Non-destructive testing of customer-supplied steel tubes and steel plate patterns"> Welding test of steel plate and steel tube

Welding test of steel plate and steel tube


Project name: Welding test of steel plate and steel tube
Related equipment: HATATEST Portable DR Inspection System
Solve the problem: Non-destructive testing of customer-supplied steel tubes and steel plate patterns


By comparing the gray value of the material and gray value with the defect provided by the customer,we have measured that the depth of the defect not welded on the workpiece is about 3.8mm.This value is a comparison value.Due to the influence of the cross section, the scattering lines and the residual height of the welded joint is not counted.The data is for reference only because there was no calibration of the test block at the scene.As shown in the first following figure.

To serve customers better and satisfy customer needs,we made a set of accurate depth measurements in a simulated field environment at company,through crest comparisons in manual test blocks and defects,the software automatically calculates the depth of defects,the accuracy of the error is 0.05mm,the second figure shows the site map, renderings and reports.As shown in the second following figure.


picture 1

blob.png

picture 2


The pipe


blob.png


blob.png


blob.png

steel plate

blob.png


blob.png


blob.png


Key words:

industrial x ray machine manufacturersportable digital x ray machine costndt x ray equipment


LAST : Adhesive testing project for aluminum plate of electric vehicle body NEXT : NDT of GIS equipment at this hydropower station

Name: Tel: E-mail:
Company:
Message:
captcha